Announcement

Collapse
No announcement yet.

LVE CPU

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • LVE CPU

    Hello,

    I just have a few questions about LVE CPU.

    From all the webinars, documentations, forums, etc., I understood that its not recommended to have LVE CPU set to less than 100% because of the CPU switches (which also consume a lot). So for example, if you set 50% for a user, it also adds the CPU switches which also consume 5%,10%, 20%, etc.

    My first question is if this also applies to higher LVE CPU values. For example, if I set 250% CPU for a user, would it also cause the overhead of 10%, 20% etc. from the CPU switch?

    Do you recommend only full CPU core/thread values, like 100%, 200%, 300% and so on or is it still feasible to cut a part of a core/thread if the value is above 100%, like 230%, 370%, 520% etc. ?

    Thank you.

  • #2
    There should not be any overhead after setting LVE limits to non-full cores, like 130% . In most cases 100% (and >100%) CPU is used by several processes, divided between cores.

    Any values above 100 would be good.

    Comment

    Working...
    X